Show Uplink-State-Group - Dell Z9500 Command Reference Manual

show uplink-state-group

Display status information on a specified uplink-state group or all groups.
Z9500
Syntax
show uplink-state-group [group-id] [detail]
Parameters
group-id
detail
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.12.0
8.4.2.3
Example
Dell# show uplink-state-group
Uplink State Group: 1 Status: Enabled, Up
Uplink State Group: 3 Status: Enabled, Up
Uplink State Group: 5 Status: Enabled, Down
Uplink State Group: 6 Status: Enabled, Up
Uplink State Group: 7 Status: Enabled, Up
Uplink State Group: 16 Status: Disabled, Up
Dell# show uplink-state-group 16
Uplink State Group: 16 Status: Disabled, Up
Dell#show uplink-state-group detail
(Up): Interface up (Dwn): Interface down (Dis): Interface
disabled
Uplink State Group
Upstream Interfaces
Downstream Interfaces :
Uplink State Group
Upstream Interfaces
Downstream Interfaces : Te 1/0(Up) Te 1/1(Up) Te 1/3(Up) Te
Uplink Failure Detection (UFD)
Displays status information on a specified uplink-state group
or all groups. The valid group-id values are from 1 to 16.
Displays additional status information on the upstream and
downstream interfaces in each group
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series S50.
: 1 Status: Enabled, Up
:
: 3 Status: Enabled, Up
: Te 0/46(Up) Te 0/47(Up)
1821