Dell Z9500 Command Reference Manual page 1297

Parameters
process-id
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.8.0
8.3.7.0
7.8.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.1.1.1
Usage If you delete all the network area commands for Area 0, the show ip ospf
Information
command output does not list Area 0.
The following describes the show ip ospf command shown in the following
example.
Line Beginning
with
"Routing
Process..."
"Supports only..."
"SPF schedule..."
"Convergence
Level"
Open Shortest Path First (OSPFv2 and OSPFv3)
Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Added output for LSA throttling timers.
Introduced on the S4810.
Added support of Multi-Process OSPF.
Added the process-id option, in support of Multi-Process
OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Description
Displays the OSPF process ID and the IP address associated
with the process ID.
Displays the number of Type of Service (TOS) rouse
supported.
Displays the delay and hold time configured for this process
ID.
1297