Ntp Broadcast Client - Dell Z9500 Command Reference Manual

The Dell Networking OS versions 8.2.1.0 and later use an encryption algorithm to
store the authentication key that is different from previous versions; beginning in
version 8.2.1.0, the system uses DES encryption to store the key in the startup-
config when you enter the ntp authentication-key command. Therefore, if
your system boots with a startup-configuration from a version prior to 8.2.1.0 in
which you have configured ntp authentication-key, the system cannot
correctly decrypt the key, and cannot authenticate NTP packets. In this case you
must re-enter this command and save the running-config to the startup-config.
Related
ntp authenticate
Commands
ntp trusted-key

ntp broadcast client

Set up the interface to receive NTP broadcasts from an NTP server.
Z9500
Syntax
ntp broadcast client
To disable broadcast, use the no ntp broadcast client command.
Defaults Disabled.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.1.1.0
1792
— enables NTP authentication.
— configures a trusted key.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
System Time and Date