Version
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
Usage
To fully enable DNS, also specify one or more domain name servers with the ip
Information
name-server command.
The system does not support sending DNS queries over a VLAN. DNS queries are
sent out all other interfaces, including the Management port.
To view current bindings, use the show hosts command.
Related
ip name-server
Commands
show hosts
ip domain-name
Configure one domain name for the switch.
Z9500
Syntax
ip domain-name name
To remove the domain name, use the no ip domain-name command.
Parameters
name
Defaults
Not configured.
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
IPv4 Routing
Description
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
— specifies a DNS server.
— Views the current bindings.
Enter one domain name to be used to complete unqualified
names (that is, incomplete domain names that cannot be
resolved).
945