Ip Pim Spt-Threshold - Dell Z9500 Command Reference Manual

Version
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.7.1.1
Usage This command configures an expiration timer for all S.G entries, unless they are
Information assigned to an Extended ACL.
Even though the FHR nodes act as RPs, these nodes still send Register encap
messages to themselves and expect to receive a Register stop message (for
Anycast RP support). As a result, if the DLT timer expires, SG is not deleted until the
register state is deleted in the node. This register state expires 210 seconds after
the last Null register is received.

ip pim spt-threshold

To switch to the shortest path tree when the traffic reaches the specified threshold value, configure the
PIM router.
Z9500
Syntax
ip pim [vrf vrf-name] spt-threshold [infinity]
To return to the default value, use the no ip pim [vrf vrf-name] spt-
threshold [infinity] command.
Parameters
vrf vrf-name
infinity
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
1388
Description
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series for the port-channels and the S-
Series.
Introduced
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to configure the PIM router on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
(OPTIONAL) Enter the keyword infinity to never switch to
the source-tree.
PIM-Sparse Mode (PIM-SM)