Ip Ospf Cost - Dell Z9500 Command Reference Manual

ip ospf cost

Change the cost associated with the OSPF traffic on an interface.
Z9500
Syntax
ip ospf cost cost
To return to default value, use the no ip ospf cost command.
Parameters
cost
Defaults The default cost is based on the reference bandwidth.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.1.1.1
Usage
If this command is not configured, cost is based on the auto-cost command.
Information
When you configure OSPF over multiple vendors, to ensure that all routers use the
same cost, use the ip ospf cost command. Otherwise, OSPF routes improperly.
Related auto-cost
Commands
Open Shortest Path First (OSPFv2 and OSPFv3)
Enter a number as the cost. The range is from 1 to 65535.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— controls how the OSPF interface cost is calculated.
1277