Fefd Interval - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

When you enter no fefd for an interface and fefd-global, FEFD is enabled on the

interface because the no fefd command is not retained in the configuration file.

To keep the interface FEFD disabled when the global configuration changes, use

the fefd reset command.

fefd interval

Set an interval between control packets.

fefd interval seconds

To return to the default value, use the no fefd interval command.

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Introduced on the Z9000.

Introduced on the S4810.

— enables FEFD globally on the system.

— changes FEFD mode on an interface.

Enter a number as the time between FEFD control packets.

The range is from 3 to 300 seconds. The default is 15

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

— enables far-end failure detection.