Tc-Flush-Standard - Dell Z9500 Command Reference Manual

Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.1
8.2.1.0
7.6.1.0
7.5.1.0
6.5.1.0
Usage On an MSTP switch, a port configured as an edge port immediately transitions to
Information the Forwarding state. Only configure ports connected to end-hosts as edge ports.
Consider an edge port similar to a port with spanning-tree portfast enabled.
If you do not enable shutdown-on-violation, BPDUs are still sent to the RPM
CPU.

tc-flush-standard

Enable the MAC address flushing after receiving every topology change notification.
Z9500
Syntax
tc-flush-standard
To disable, use the no tc-flush-standard command.
Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1250
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced the hardware shutdown-on-violation
option.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Multiple Spanning Tree Protocol (MSTP)