Tagged Port-Channel - Dell Z9500 Command Reference Manual

Dell(conf-if-te-1/0)#vlan-stack trunk
Dell(conf-if-te-1/0)#exit
Dell(config)#interface vlan 10
Dell(conf-if-vlan)#vlan-stack compatible
Dell(conf-if-vlan)#member Te 0/0, Te 1/0, Te 2/10
Dell(conf-if-vlan)#exit
Dell(config)#interface vlan 30
Dell(conf-if-vlan)#untagged TenGi 1/0
Dell(conf-if-vlan)#exit
Dell(config)#
Dell(config)#interface vlan 40
Dell(conf-if-vlan)#tagged TenGi 1/0
Dell(conf-if-vlan)#exit
Dell(config)#

tagged port-channel

Specify tagged VLAN ports.
Z9500
Syntax
tagged port-channel port-channel-number
To remove tagged VLAN ports, use the no tagged port-channel port-
channel-number command.
Parameters
port-channel-
number
Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
1834
Enter the port-channel number. The range is from 1 to 512.
Description
Introduced on the S-Series and Z-Series.
VLAN Stacking