Multicast - Dell Z9500 Command Reference Manual

Multicast

The multicast commands are supported by Dell Networking operating system.
This chapter contains the following sections:
• IPv4 Multicast Commands
• IPv6 Multicast Commands
IPv4 Multicast Commands
This section describes the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent
multicast (PIM) tree information base, use the clear ip pim tib command.
Z9500
Syntax
clear ip mroute [vrf vrf-name] {group-address [source-address]
| * | snooping}
Parameters
vrf vrf-name
group-address
[source-
address]
*
snooping
Command EXEC Privilege
Modes
Multicast
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to configure this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
Enter the multicast group address and source address (if
desired), in dotted decimal format, to clear information on a
specific group.
Enter * to clear all multicast routes.
Enter the keyword snooping to delete multicast snooping
route table entries.
32
1205