Source (Port Monitoring) - Dell Z9500 Command Reference Manual

Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.11.1
8.1.1.0
7.7.1.0
7.5.1.0
7.4.1.0
Usage The monitoring command is saved in the running configuration at the Monitor
Information Session mode level and can be restored after a chassis reload.
Example
Dell(conf-mon-sess-0)#do show running-config monitor session
!
monitor session 0
source Port-channel 10 destination TenGigabitEthernet 0/33
direction tx
!
Related
monitor session
Commands
show monitor session

source (port monitoring)

Configure a port monitor source.
Syntax
source {interface | range | any} destination interface
direction {rx | tx | both}
1442
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— creates a monitoring session.
— displays a monitoring session.
Port Monitoring