Dell Z9500 Command Reference Manual page 1289

Hide thumbs Also See for Z9500:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Although the passive interface does not send or receive routing updates, the

network on that interface is still included in OSPF updates sent using other

The default keyword sets all interfaces as passive. You can then configure

individual interfaces, where adjacencies are desired, using the no passive-

interface interface command. The no form of this command is inserted into

the configuration for individual interfaces when the no passive-interface

interface command is issued while passive-interface default is

This command behavior has changed as follows:

passive-interface interface

passive-interface default

Open Shortest Path First (OSPFv2 and OSPFv3)

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Added support for Multi-Process OSPF.

Introduced on the S-Series.

Introduced on the C-Series.

Modified to include the keyword default.

Introduced on the E-Series.

The previous no passive-interface interface is removed from the

running configuration.

The ABR status for the router is updated.

Save passive-interface interface into the running configuration.

All present and future OSPF interfaces are marked as passive.

Any adjacency is explicitly terminated from all OSPF interfaces.

All previous passive-interface interface commands are removed from

the running configuration.