Match Ip Vlan - Dell Z9500 Command Reference Manual

Related
class-map
Commands

match ip vlan

Uses a VLAN as the match criterion for an L3 class map.
Z9500
Syntax
match ip vlan vlan-id
To remove VLAN as the match criterion, use the no match ip vlan vlan-id
command.
Parameters
vlan vlan-id
Defaults none
Command CONF-CLASS-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.4.(0.0)
Usage To access this command, enter the class-map command. After the class map is
Information
identified, you can configure the match criteria.
Use this command to match an IP class-map against a single VLAN ID .
Related class-map
Commands
match mac access-group
Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
Z9500
Syntax
match mac access-group {mac-acl-name}
Parameters
mac-acl-name
Quality of Service (QoS)
— identifies the class map.
Enter the keyword vlan and then the ID of the VLAN. The
range is from 1 to 4094.
Description
Introduced on the Z9500.
Introduced on the S-Series and Z-Series.
— identifies the class map.
Enter a MAC ACL name. Its contents is used as the match
criteria in the class map.
1495