Ip Msdp Peer - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

ip msdp peer

Configure an MSDP peer.

ip msdp peer peer address [connect-source] [description] [sa-

limit number]

To remove the MSDP peer, use the no ip msdp peer peer address

[connect-source interface] [description name] [sa-limit number]

peer address

As described in the Parameters section.

Introduced on the Z9000.

Introduced on the S4810.

Added support for 4-port 40G line cards on ExaScale.

Enter the peer address in a dotted decimal format (A.B.C.D.).

Enter the keywords connect-source then one of the

interfaces and slot/port or number information:

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For a port channel interface, enter the keywords port-

channel then a number. The range is from 1 to 512.

For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

(OPTIONAL) Enter the keyword description then a

description name (maximum 80 characters) to designate a

description for the MSDP peer.

(OPTIONAL) Enter the maximum number of SA entries in SA-

cache. The range is from 1 to 100000. .

Multicast Source Discovery Protocol (MSDP)