Management Crypto-Policy - Dell Z9500 Command Reference Manual

Usage This command creates a crypto policy entry and enters the crypto policy
Information configuration mode for configuring the flow parameters.
Example
Dell(conf)#crypto ipsec policy West 10 ipsec-manual
Dell(conf-crypto-policy)#

management crypto-policy

Apply the crypto policy to management traffic.
Z9500
Syntax
management crypto-policy name
To remove the management traffic crypto policy, use the no management
crypto-policy name command.
Parameters
name
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.2(0.0)
match
Apply an match filter to the crypto policy.
Z9500
Syntax
match seq-num tcp [sourceip address | ipv6 address {mask}
{source-port number}] [destination ip address | ipv6 address
{mask} {destination-port number}]
918
Enter the name for the crypto policy..
Description
Introduced on the Z9500.
Introduced on the Z9000, S4810, and S4820T.
Internet Protocol Security (IPSec)