Show Arp - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

When a static route (or a protocol route) overlaps with Management static route,

the static route (or a protocol route) is preferred over the Management Static route.

Also, Management static routes and the Management Connected prefix are not

reflected in the hardware routing tables. Separate routing tables are maintained for

IPv4 and IPv6 management routes. This command manages both tables.

interface ManagementEthernet

(either the Primary or Standby RPM).

speed (Management interface)

show arp

Display the ARP table.

show arp [interface interface | ip ip-address [mask] |

macaddress mac-address [mac-address mask]] [retries] [static |

dynamic] [inspection {database | statistics][summary]

IPv4 Routing

Added support for forty gigabit, vlan, and tengigabit ethernet

interfaces. Introduced on the S6000-ON.

Introduced on the S6000.

Introduced on the Z9000 and added support for IPv6.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the E-Series ExaScale.

Introduced on the C-Series.

Introduced on the E-Series.

— configures the Management port on the system

— sets the speed for the Management interface.

(OPTIONAL) Enter the following keywords and slot/port or

number information:

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.