Show Config - Dell Z9500 Command Reference Manual

Version
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
7.8.1.0
6.3.1.0
Usage Set the overload bit when a router experiences problems, such as a memory
Information shortage due to an incomplete link state database which can result in an
incomplete or inaccurate routing table. If you set the overload bit in its LSPs, other
routers ignore the unreliable router in their SPF calculations until the router has
recovered.

show config

Display the changes you made to the IS-IS configuration. Default values are not shown.
Z9500
Syntax
show config
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.1
Intermediate System to Intermediate System (IS-IS)
Description
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Added support for multi-topology ISIS.
Introduced.
ROUTER ISIS (for IPv4)
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Description
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
1113