Storm-Control Unknown-Unicast (Interface) - Dell Z9500 Command Reference Manual

storm-control unknown-unicast (Interface)

Configure percentage of unknown-unicast traffic allowed on an interface (ingress only).
Z9500
Syntax
storm-control unknown-unicast [percentage decimal_value in] |
[wred-profile name]] [packets_per_second in]
To disable unknown-unicast storm control on the interface, use the no storm-
control unknown-unicast [percentage decimal_value in] | [wred-
profile name]] [packets_per_second in] command.
Parameters
percentage
decimal_value
[in | out]
wred-profile
name
packets_per_se
cond in
Defaults none
Command INTERFACE (conf-if-interface-slot/port)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
1766
E-Series Only: Enter the percentage of broadcast traffic
allowed in or out of the network. Optionally, you can
designate a decimal value percentage, for example, 55.5%.
The percentage is from 0 to 100:
• 0% blocks all related traffic.
• 100% allows all traffic into the interface.
The decimal range is from 0.1 to 0.9.
E-Series Only: (Optionally) Enter the keywords wred-
profile followed by the profile name to designate a wred-
profile.
C-Series and S-Series Only: Enter the packets per second of
broadcast traffic allowed into the network. The range is from
0 to 33554431.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Storm Control