Dell Z9500 Command Reference Manual page 1207

mask
null 0
[protocol
[process-id |
tag] ip-address]
static ip-
address
ip-address
distance
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.7.0
E-Series legacy
command
Related show ip mroute
Commands
Multicast
Enter the mask in slash prefix formation ( /x ) or in dotted
decimal format.
(OPTIONAL) Enter the keyword null then zero (0).
(OPTIONAL) Enter one of the routing protocols:
• Enter the BGP as-number then the IP address in dotted
decimal format of the reverse path forwarding (RPF)
neighbor. The range is from 1 to 65535.
• Enter the OSPF process identification number then the IP
address in dotted decimal format of the RPF neighbor.
the range is from 1 to 65535.
• Enter the IS-IS alphanumeric tag string then the IP
address in dotted decimal format of the RPF neighbor.
• Enter the RIP IP address in dotted decimal format of the
RPF neighbor.
(OPTIONAL) Enter the Static IP address in dotted decimal
format of the RPF neighbor.
(OPTIONAL) Enter the IP address in dotted decimal format of
the RPF neighbor.
(OPTIONAL) Enter a number as the distance metric assigned
to the mroute. The range is from 0 to 255.
Description
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
— displays the routing table.
1207