Vlan-Stack Trunk - Dell Z9500 Command Reference Manual

vlan-stack trunk

Specify a Layer 2 port or port channel as a trunk port to the Stackable VLAN network.
Z9500
Syntax
vlan-stack trunk
To remove a trunk port designation from the selected interface, use the no vlan-
stack trunk command.
Defaults Not configured.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Netowrking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
7.8.1.0
7.7.1.0
7.6.1.0
Usage
Prior to using this command, to place the interface in Layer 2 mode, execute the
Information
switchport command.
To remove the trunk port designation, first remove the port (using the no member
interface command) from all stackable VLAN-enabled VLANs.
A VLAN-Stack trunk port is also allowed to be configured as a tagged port and as
an untagged port for single-tagged VLANs. When the VLAN-Stack trunk port is also
a member of an untagged VLAN, the port must be in Hybrid mode. Refer to
portmode
1832
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale. C-Series and S-Series
accept both bytes of the 2-byte S-Tag TPID.
Functionality augmented for C-Series and S-Series to
enable multi-purpose use of the port.
Functionality augmented for E-Series to enable multi-
purpose use of the port.
Introduced on the C-Series and S-Series.
hybrid.
VLAN Stacking