Default-Information Originate - Dell Z9500 Command Reference Manual

default-information originate

Generate a default route for the RIP traffic.
Z9500
Syntax
default-information originate [always] [metric metric-value]
[route-map map-name]
To return to the default values, use the no default-information originate
command.
Parameters
always
metric metric-
value
route-map
map-name
Defaults Disabled. Metric: 1.
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
6.2.1.1
Usage The default route must be present in the switch routing table for the default-
Information information originate command to take effect.
Routing Information Protocol (RIP)
(OPTIONAL) Enter the keyword always to enable the switch
software to always advertise the default route.
(OPTIONAL) Enter the keyword metric then a number as
the metric value. The range is from 1 to 16. The default is 1.
(OPTIONAL) Enter the keywords route-map then the name
of a configured route-map.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1535