Sflow Sample-Rate (Interface) - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:
Table of Contents

Advertisement

Version
8.3.7.0
8.2.1.0
8.1.1.0
7.7.1.0
7.6.1.0
7.4.1.0
Usage
Sample-rate is the average number of packets skipped before the sample is taken.
Information
This command changes the global default sampling rate. You can configure an
interface to use a different sampling rate than the global sampling rate. If the value
entered is not a correct power of 2, the command generates an error message
with the previous and next power of 2 value. Select one of these two packet
numbers and re-enter the command.
Related

sflow sample-rate (Interface)

Commands
sflow sample-rate (Interface)
Change the interface default sampling rate.
Z9500
Syntax
sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate
command.
Parameters
value
Defaults
The Global default sampling.
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1700
Description
Introduced on the S4810.
Introduced on S-Series Stacking.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— changes the interface sampling rate.
Enter the sampling rate value. For the C-Series and S-Series,
the range is from 256 to 8388608 packets.Enter values in
powers of 2 only; for example, 4096, 8192, 16384, etc. The
default is the Global default sampling.
sFlow

Advertisement

Table of Contents
loading

Table of Contents