Show Ip Ospf Topology - Dell Z9500 Command Reference Manual

show ip ospf topology

Display routers in directly connected areas.
Z9500
Syntax
show ip ospf process-id topology
Parameters
process-id
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
7.5.1.0
Usage To isolate problems with inter-area and external routes, use this command. In
Information OSPF inter-area and external routes are calculated by adding LSA cost to the cost
of reaching the router. If an inter-area or external route is not of correct cost, the
display can determine if the path to the originating router is correct or not.
Example
Dell#show ip ospf 1 topology
Router ID
3.3.3.3
1.1.1.1
Dell#
1328
Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
EXEC
EXEC Privilege
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series and E-Series.
Flags Cost
E/B/-/ 1
E/-/-/ 1
Nexthop Interface Area
20.0.0.3 Te 13/1
10.0.0.1 Te 7/1
Open Shortest Path First (OSPFv2 and OSPFv3)
0
1