Dell Z9500 Command Reference Manual page 1162

Hide thumbs Also See for Z9500:

Table of Contents

Not configured.

INTERFACE VLAN

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

When this command is configured, the VLAN is operationally UP if any of the

interfaces specified in the track ip command are operationally UP, and the VLAN

is operationally DOWN if none of the tracking interfaces are operationally UP.

If the track ip command is not configured, the VLAN's Layer 3 operational state

depends on all the members of the VLAN.

The Layer 2 state of the VLAN, and hence the Layer 2 traffic, is not affected by the

track ip command configuration.

interface vlan

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

Introduced on the S6000-ON.

Introduced on the Z9500.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the Z9000.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.

— configures a VLAN.

— specifies which interfaces in a VLAN are tagged.