Show Ip Flow - Dell Z9500 Command Reference Manual

show ip flow

Show how a Layer 3 packet is forwarded when it arrives at a particular interface.
Z9500
Syntax
show ip flow interface interface {source-ip address
destination-ip address} {protocol number [tcp | udp]} {src-port
number destination-port number}
Parameters
interface
interface
source-ip
address
destination-ip
address
protocol
number [tcp |
udp]
src-port
number
destination-
port number
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.10.0
8.5.1.0
972
Enter the keyword interface then one of the following
interface keywords.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Enter the keywords source-ip then the IP source address
in IP address format.
Enter the keywords destination-ip then the IP
destination address in IP address format.
Enter the keyword protocol then one of the protocol type
keywords: tcp, udp, or protocol number The protocol
number range is from 0 to 255. .
Enter the keywords src-port then the source port number.
Enter the keywords destination-port then the destination
port number.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
IPv4 Routing