Lsp-Refresh-Interval - Dell Z9500 Command Reference Manual

Version
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
7.5.1.0
Usage
The link MTU and the LSP MTU size must be the same.
Information
Because each device can generate a maximum of 255 LSPs, consider carefully
whether you use the lsp-mtu command.

lsp-refresh-interval

Set the link state PDU (LSP) refresh interval. LSPs must be refreshed before they expire. When the LSPs are
not refreshed after a refresh interval, they are kept in a database until their max-lsp-lifetime reaches
zero and then LSPs is purged.
Z9500
Syntax
lsp-refresh-interval seconds
To restore the default refresh interval, use the no lsp-refresh-interval
command.
Parameters
seconds
Defaults 900 seconds
Command ROUTER ISIS
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1098
Description
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Added support for LSP Throttling Enhancement.
The LSP refresh interval, in seconds. This value has to be less
than the seconds value specified with the max-lsp-
lifetime command. The range is from 1 to 65535 seconds.
The default is 900.
Intermediate System to Intermediate System (IS-IS)