Ipv6 Pim Commands - Dell Z9500 Command Reference Manual

IPv6 PIM Commands

The following commands apply to IPv6 PIM-SM and IPv6 PIM-SSM.
• clear ipv6 pim tib
• debug ip pim
• ipv6 pim dr-priority
• ipv6 pim join-filter
• ipv6 pim query-interval
• ipv6 pim neighbor-filter
• show ipv6 pim interface
• show ipv6 pim neighbor
• show ipv6 pim tib
IPv6 PIM-Source Specific Mode Commands
This section describes the IPv6 PIM-SSM commands.
ipv6 pim ssm-range
Specify the SSM group range using an access list.
Syntax
ipv6 pim ssm-range {access_list_name}
Parameters
access_list_na
me
Defaults Default SSM range is 232/8 and ff3x/32
Command CONFIGURATION
Modes
Command
Version 9.5(0.1)
History
Version 7.5.1.0
Usage
After the SSM range is applied, the changes are applied internally without requiring
Information
clearing of the TIB. The SSM ACL overrides the default range. To use the default
range while the SSM range is active, add the default range to the SSM ACL.
PIM-Source Specific Mode (PIM-SSM)
Enter the name of the access list. Maximum 16 characters.
Introduced on the Z9500.
Introduced on the E-Series.
1421