Ipv6 Pim Bsr-Candidate - Dell Z9500 Command Reference Manual

Defaults Disabled.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
8.3.19.0
8.3.12.0
7.4.1.0

ipv6 pim bsr-candidate

Configure the router as a bootstrap (BSR) candidate.
Syntax
ipv6 pim bsr-candidate interface [hash-mask-length] [priority]
To disable the bootstrap candidate, use the no ipv6 pim bsr-candidate
command.
Parameters
interface
hash-mask-
length
PIM-Sparse Mode (PIM-SM)
• hello: to view the IPv6 PIM neighbor keepalive timer
• joinprune: to view the expiry timer (join/prune timer)
• register: to view the register suppression timer
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S6000.
Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
(OPTIONAL) Enter the hash mask length for RP selection.
The range is from 0 to 128. The default is 126.
1405