Downstream - Dell Z9500 Command Reference Manual

downstream

Assign a port or port-channel to the uplink-state group as a downstream interface.
Z9500
Syntax
downstream interface
To delete an uplink-state group, enter the no downstream interface
command.
Parameters
interface
Defaults none
Command UPLINK-STATE-GROUP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.12.0
8.4.2.3
Usage
You can assign physical port or port-channel interfaces to an uplink-state group.
Information
1816
Enter one of the following interface types:
• 10-Gigabit Ethernet: tengigabitethernet {slot/
port |slot/port-range}
• 40-Gigabit Ethernet: fortyGigE {slot/port |slot/
port-range}
• Port channel: port-channel {1-512 | port-
channel-range}
Where port-range and port-channel-range specify a
range of ports separated by a dash (-) and/or individual
ports/port channels in any order; for example:
tengigabitethernet 1/1-2,5,9,11-12 port-
channel 1-3,5. A comma is required to separate each port
and port-range entry.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series S50.
Uplink Failure Detection (UFD)