Dell Z9500 Command Reference Manual page 1116

Field
LSP Seq Num
LSP Checksum
LSP Holdtime
ATT
P
OL
Example
The bold sections identify that MultiTopology IS-IS is enabled.
Dell#show isis database
IS-IS Level-1 Link State Database
LSPID
ISIS.00-00 * 0x00000006 0xCF43
IS-IS Level-2 Link State Database
LSPID
ISIS.00-00 * 0x00000006 0xCF43
!
Dell#show isis database detail ISIS.00-00
IS-IS Level-1 Link State Database
LSPID
ISIS.00-00 * 0x0000002B 0x853B
1116
Description
The last octet is the LSP number. An LSP is divided into
multiple LSP fragments if there is more data than cannot fit
in a single LSP. Each fragment has a unique LSP number.
An * after the LSPID indicates that the system originates an
LSP where this command was issued.
This value is the sequence number for the LSP that allows
other systems to determine if they have received the latest
information from the source.
This is the checksum of the entire LSP packet.
This value is the amount of time, in seconds, that the LSP
remains valid. A zero holdtime indicates that this is a purged
LSP and is being removed from the link state database. A
value between brackets indicates the duration that the
purged LSP stays in the database before being removed.
This value represents the Attach bit. This value indicates that
the router is a Level 1-2 router and can reach other areas.
Level 1-only routers and Level 1-2 routers that have lost
connection to other Level 1-2 routers use the Attach bit to
find the closest Level 1-2 router. They install a default route
to the closest Level 1-2 router.
This value represents the P bit. This bit is always set to zero
as Dell Networking does not support area partition repair.
This value represents the overload bit, determining
congestion. If the overload bit is set, other routers do not
use this system as a transit router when calculating routes.
LSP Seq Num LSP Checksum LSP Holdtime ATT/P/OL
LSP Seq Num LSP Checksum LSP Holdtime ATT/P/OL
LSP Seq Num LSP Checksum LSP Holdtime ATT/P/OL
Area Address: 49.0000.0001
NLPID: 0xCC 0x8E
IP Address: 10.1.1.1
IPv6 Address: 1011::1
Topology: IPv4 (0x00) IPv6 (0x8002)
Metric: 10 IS OSPF.00
580 0/0/0
580 0/0/0
1075 0/0/0
Intermediate System to Intermediate System (IS-IS)