Advertise Dot3-Tlv - Dell Z9500 Command Reference Manual

port-vlan-id
vlan-name
Defaults Disabled.
Command CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
7.4.1.0
Related
protocol lldp (Configuration)
Commands
debug lldp interface
show lldp neighbors
show running-config lldp

advertise dot3-tlv

Advertise dot3 TLVs (Type, Length, Value).
Z9500
Syntax
advertise dot3-tlv {max-frame-size}
To remove advertised dot3-tlv, use the no advertise dot3-tlv {max-frame-
size} command.
Link Layer Discovery Protocol (LLDP)
Enter the keywords port-vlan-id to advertise the port
VLAN identification TLV.
Enter the keywords vlan-name to advertise the vlan-name
TLV. This keyword is only supported on the C-Series and S-
Series.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series. Added the vlan-name option.
Introduced on the C-Series.
Introduced on the E-Series.
— enables LLDP globally.
— debugs LLDP.
— displays the LLDP neighbors.
— displays the LLDP running configuration.
1175