Show Config - Dell Z9500 Command Reference Manual

After the OSPF process and the VRF are tied together, you cannot use the OSPF
Process ID again in the system.
Example
Dell(conf)#router ospf 2
Dell(conf-router_ospf)#

show config

Display the non-default values in the current OSPF configuration.
Z9500
Syntax
show config
Command ROUTER OSPF
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.1.1.1
Example
Dell(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
Dell(conf-router_ospf)#
show ip ospf
Display information on the OSPF process configured on the switch.
Z9500
Syntax
show ip ospf process-id [vrf vrf name]
1296
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Open Shortest Path First (OSPFv2 and OSPFv3)