Dell Z9500 Command Reference Manual page 1448

Hide thumbs Also See for Z9500:

Table of Contents

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Only ports (and port channels) configured as promiscuous, host, or PVLAN trunk

ports (as previously described) can be added to the PVLAN. No other regular ports

can be added to the PVLAN.

After using this command to configure a VLAN as a primary VLAN, use the

private-vlan mapping secondary-vlan command to map secondary VLANs

to this VLAN.

private-vlan mapping secondary-vlan

primary VLAN.

show interfaces private-vlan

show vlan private-vlan

switchport mode private-vlan

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the C-Series and S-Series.

can be in only one mode, either community, isolated, or primary.

mode ode to community or isolated even before associating it to a primary

VLAN. This secondary VLAN continues to work normally as a normal VLAN even

though it is not associated to a primary VLAN. (A syslog message indicates this.)

must not have a port in it when VLAN mode is being set.

— displays the PVLANs and/or interfaces that are part of a

— maps secondary VLANs to the selected

— displays the type and status of the PVLAN

— sets PVLAN mode of the selected port.

Private VLAN (PVLAN)