Hello - Dell Z9500 Command Reference Manual

Version
7.7.1.0
7.6.1.0
7.4.1.0
Related
protocol lldp (Configuration)
Commands
debug lldp interface
show lldp neighbors
show running-config lldp

hello

Configure the rate at which the LLDP control packets are sent to its peer.
Z9500
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds
Defaults 30 seconds
Command CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
1182
Description
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— enables LLDP globally.
— debugs LLDP.
— displays the LLDP neighbors.
— displays the LLDP running configuration.
Enter the rate, in seconds, at which the control packets are
sent to its peer. The rate is from 5 to 180 seconds. The
default is 30 seconds.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Link Layer Discovery Protocol (LLDP)