To disable a monitor source, use the no source interface destination
interface direction {rx | tx | both} command.
Parameters
source
interface
range
any
destination
interface
direction {rx | tx
| both}
Port Monitoring
Enter one of the following keywords and slot/port
information:
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a VLAN interface enter the keyword VLAN followed by
a number from 1 to 4094.
•
For a port channel interface, enter the keywords port-
channel then a number.
Enter the keyword range to specify the list of interfaces.
Enter the keyword any to specify all interfaces.
NOTE: This option is applicable only with drop monitor
session.
Enter the keyword destination to specify the destination
interface.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a port channel interface, enter the keywords port-
channel then a number.
Enter one of the following keywords and slot/port
information:
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
•
For a port channel interface, enter the keywords port-
channel then a number.
Enter the keyword direction then one of the packet
directional indicators.
•
rx: to monitor receiving packets only.
•
tx: to monitor transmitting packets only.
•
both: to monitor both transmitting and receiving
packets.
1443