Dell Z9500 Command Reference Manual page 955

Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.2.(0.0)
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
8.2.1.0
8.1.1.0
7.9.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Usage Using the following example of a static route: ip route 33.33.33.0 /24
Information tengigabitethernet 0/0 172.31.5.43
•
•
•
•
•
Related show ip route
Commands
show ipv6 route
IPv4 Routing
Description
Introduced on the Z9500.
Added support for tunnel interface type.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Added support for 4094 VLANs on the E-Series ExaScale
(the prior limit was 2094).
Introduced on the E-Series ExaScale.
Introduced VRF on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
The software installs a next hop that is not on the directly connected subnet but
which recursively resolves to a next hop on the interface's configured subnet. In
the example, if te 0/0 has an ip address on subnet 2.2.2.0 and if 172.31.5.43
recursively resolves to 2.2.2.0, the system installs the static route.
When the interface goes down, the system withdraws the route.
When the interface comes up, the system re-installs the route.
When recursive resolution is "broken," the system withdraws the route.
When recursive resolution is satisfied, the system re-installs the route.
— views the switch routing table.
— displays the IPv6 routes.
955