Dell Z9500 Command Reference Manual page 1149

Hide thumbs Also See for Z9500:

Table of Contents

interface-type

vlan vlan-id

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

The following describes the show mac-address-table command shown in the

following example.

(OPTIONAL) Enter the keyword interface then the

interface type, slot and port information:

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

(OPTIONAL) Instead of entering the keyword interface

then the interface type, slot and port information, as above,

you can enter the interface type, then just a slot number.

(OPTIONAL) Enter the keyword vlan then the VLAN ID to

display the MAC address assigned to the VLAN. The range is 1

(OPTIONAL) Enter the keyword count, then optionally, by an

interface or VLAN ID, to display total or interface-specific

static addresses, dynamic addresses, and MAC addresses in

EXEC Privilege

Introduced on the Z9500.

Introduced on the S4820T.

Introduced on the Z9000.

Updated the output.

Added support for 4-port 40G line cards on ExaScale.

Introduced on the S4810.

Introduced on the S-Series.

Introduced on the C-Series.

Introduced on the E-Series.