Show Ip Pim Snooping Neighbor - Dell Z9500 Command Reference Manual

Example (#2)
Dell#show ip pim snooping interface
Interface Ver Nbr
Vlan 2

show ip pim snooping neighbor

Display information on PIM neighbors learned through PIM-SM snooping.
Syntax
show ip pim snooping neighbor [vlan vlan-id]
Parameters
vlan vlan-id
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
8.3.19.0
8.3.12.0
8.4.1.1
Usage The following describes the show ip pim snooping neighbor commands
Information shown in the following example.
Field
Neighbor address
Interface
Uptime/expires
Ver
1396
Count
v2 3
(OPTIONAL) Enter a VLAN ID to display information about
PIM neighbors that PIM-SM snooping discovered on a
specified VLAN. The valid VLAN IDs range is from 1 to 4094.
EXEC
EXEC Privilege
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Description
Displays the IP address of the neighbor learned through
PIM-SM snooping.
Displays the VLAN ID number and slot/port on which the
PIM-SM-enabled neighbor was discovered.
Displays the amount of time the neighbor has been up then
the amount of time until the neighbor is removed from the
multicast routing table (that is, until the neighbor hold time
expires).
Displays the PIM version number:
DR DR
Prio
1 165.87.32.2
PIM-Sparse Mode (PIM-SM)