Sflow Collector - Dell Z9500 Command Reference Manual

sflow collector

Configure a collector device to which sFlow datagrams are forwarded.
Z9500
Syntax
sflow collector {ip-address | ipv6-address} agent-addr {ip-
address | ipv6-address} [number [max-datagram-size number]] |
[max-datagram-size number]
To delete a configured collector, use the no sflow collector {ip-address |
ipv6-address} agent-addr {ipv4-address | ipv6-address} [number
[max-datagram-size number]] | [max-datagram-size number]
command.
Parameters
sflow collector
ip-address |
ipv6-address
agent-addr ip-
address | ipv6-
address
number
max-
datagram-size
number
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
1692
Enter the IP address of the collector in dotted decimal
format for IPv4 or x:x:x:x::x format for IPv6.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the keyword agent-addr followed by the sFlow agent
IP address in dotted decimal format for IPv4 or x:x:x:x::x
format for IPv6.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
(OPTIONAL) Enter the user datagram protocol (UDP) port
number. The range is from 0 to 65535. The default is 6343.
(OPTIONAL) Enter the keyword max-datagram-size then the
size number in bytes. The range is from 400 to 1500. The
default is 1400.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
sFlow