Rate-Interval - Dell Z9500 Command Reference Manual

Example
Dell(conf-if-vl-20)#do show interfaces switchport
Name: TenGigabitEthernet 2/0
802.1QTagged: Hybrid
Vlan membership:
Vlan
Native
Dell(conf-if-vl-20)#
Example (Vlan)
Dell(conf-if-vl-20)#interface vlan 10
Dell(conf-if-vl-10)#no untagged te 2/0
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#no tagged te 2/0
Dell(conf-if-vl-20)#interface te 2/0
Dell(conf-if-te-2/0)#no portmode hybrid
Dell(conf-if-vl-20)#
Related
switchport
Commands
vlan-stack trunk
network.

rate-interval

Configure the traffic sampling interval on the selected interface.
Z9500
Syntax
rate-interval seconds
Parameters
seconds
Defaults 299 seconds
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
862
10, Vlan 20
VlanId: 10
— places the interface in a Layer 2 mode.
— specifies an interface as a trunk port to the Stackable VLAN
Enter the number of seconds for which to collect traffic data.
The range is from 5 to 299 seconds.
NOTE: Because polling occurs every 15 seconds, the
number of seconds designated here rounds to the
multiple of 15 seconds lower than the entered value. For
example, if 44 seconds is designated, it rounds to 30; 45
to 59 seconds rounds to 45.
Description
Introduced on the Z9500.
Interfaces