Show Running-Config Monitor Session - Dell Z9500 Command Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.4.0.0
9.0.2.0
8.3.19.0
8.3.7.0
8.3.11.1
8.1.1.0
7.7.1.0
7.5.1.0
7.4.1.0
Example
Dell#show monitor session
Dest IP
--------
A
A
72.72.72.2
Related monitor session
Commands

show running-config monitor session

Display the running configuration of all monitor sessions or a specific session.
Z9500
Syntax
show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use the show
running-config monitor session command.
Parameters
session-ID
Port Monitoring
Description
Introduced on the Z9500.
Added support for the RPM / ERPM.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
SessID Source Destination
------ ------ -----------
1 Te 0/1
N/A
2 Po 128
N/A
3 Te 0/2
— creates a monitoring session.
(OPTIONAL) Enter a session identification number. The range
from 0 to 65535.
Dir
---
Te 0/4 both
remote-vlan 100
remote-ip
Mode Source IP
---- ---------
Port N/
tx Port N/
rx Port 36.36.36.1
1441