Snmp-Server Host - Dell Z9500 Command Reference Manual

Usage The following Example specifies the group named harig as a version 3 user
Information requiring both authentication and encryption and read access limited to the read
named rview.
Example
Dell#conf
Dell(conf)# snmp-server group harig 3 priv read rview
Dell#
Related
show snmp group
Commands
storage type of each group.
show running-config

snmp-server host

Configure the recipient of an SNMP trap operation.
Z9500
Syntax
snmp-server host ip-address | ipv6-address [traps | informs]
[version 1 | 2c | 3] [auth | no auth | priv] [community-string]
[udp-port port-number] [notification-type]
To remove the SNMP host, use the no snmp-server host ip-address
[traps | informs] [version 1 | 2c | 3] [auth | noauth | priv]
[community-string] [udp-port number] [notification-type]
command.
Parameters
ip-address
ipv6-address
traps
informs
version 1 | 2c |
3
1718
NOTE: The number of configurable groups is limited to 16 groups.
— displays the group name, security model, view status, and
— displays the SNMP running configuration.
Enter the keyword host then the IP address of the host
(configurable hosts is limited to 16).
Enter the keyword host then the IPv6 address of the host in
the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
(OPTIONAL) Enter the keyword traps to send trap
notifications to the specified host. The default is traps.
(OPTIONAL) Enter the keyword informs to send inform
notifications to the specified host. The default is traps.
(OPTIONAL) Enter the keyword version to specify the
security model then the security model version number 1,
2c, or 3:
• Version 1 is the least secure version.
• Version 3 is the most secure of the security modes.
Simple Network Management Protocol (SNMP) and Syslog