Ip Ospf Retransmit-Interval - Dell Z9500 Command Reference Manual

Usage
Setting a priority of 0 makes the router ineligible for election as a designated router
Information
or backup designated router.
Use this command for interfaces connected to multi-access networks, not point-
to-point networks.

ip ospf retransmit-interval

Set the retransmission time between lost link state advertisements (LSAs) for adjacencies belonging to the
interface.
Z9500
Syntax
ip ospf retransmit-interval seconds
To return to the default values, use the no ip ospf retransmit-interval
command.
Parameters
seconds
Defaults 5 seconds
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.1.1.1
Open Shortest Path First (OSPFv2 and OSPFv3)
Enter the number of seconds as the interval between
retransmission. The range is from 1 to 3600. The default is 5
seconds.
This interval must be greater than the expected round-trip
time for a packet to travel between two routers.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1283