Debug Ip Pim - Dell Z9500 Command Reference Manual

Version
8.3.7.0
8.1.1.0
7.8.1.0
Usage If you use this command on a local VLT node, all multicast routes from the local
Information PIM TIB, the entire multicast route table, and all the entries in the data plane are
deleted. The local VLT node sends a request to the peer VLT node to download
multicast routes learned by the peer. Both local and synced routes are removed
from the local VLT node multicast route table. The peer VLT node clears synced
routes from the node.
If you use this command on a peer VLT node, only the synced routes are deleted
from the multicast route table.

debug ip pim

View IP PIM debugging messages.
Z9500
Syntax
debug ip pim [vrf vrf-name] [bsr | events | group | packet [in
| out] | register | state | timer [assert | hello | joinprune |
register]]
To disable PIM debugging, use the no debug ip pim [vrf vrf-name]
command or use the undebug allto disable all debugging command.
Parameters
vrf vrf-name
bsr
events
group
packet [in | out]
PIM-Sparse Mode (PIM-SM)
Description
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to view IP PIM debugging messages corresponding
to that VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
(OPTIONAL) Enter the keyword bsr to view PIM Candidate
RP/BSR activities.
(OPTIONAL) Enter the keyword group to view PIM messages
for a specific group.
(OPTIONAL) Enter the keyword group to view PIM messages
for a specific group.
(OPTIONAL) Enter the keyword packet to view PIM packets.
Enter one of the optional parameters:
• in: to view incoming packets
• out: to view outgoing packets
1375