Dell Z9500 Command Reference Manual page 1338

Parameters
interface
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.2.(0.0)
Usage The following section describes the command fields.
Information
Lines Beginning
With or Including
OSPFv3...
05:21:01
Sending Ver:3
Example
Dell(conf-if-te-1/2)#do debug ipv6 ospf bfd te 1/2
OSPFv3 bfd related debugging is on for TenGigabitEthernet 1/2
00:59:26 : OSPFv3INFO: Received Interface mode bfd config
command on interface Te 1/2 Enable 1, interval 0, min_rx 0,
Multiplier 0, role 0, Disable 0
00:59:26 : OSPFv3INFO: Enabling BFD on interface Te 1/2 Cmd
Add Session
00:59:27 : OSPFv3INFO: Enabling BFD for NBRIP
fe80:0000:0000:0000:0201:e8ff:fe8b:7720
00:59:27 : OSPFv3INFO: Completed Enabling BFD on interface Te
1/2
00:59:27 : OSPFv3INFO: Completed Interface mode BFD
configuration on Te 1/2!!
00:59:27 : OSPFv3INFO: Enabling BFD for NBRIP
fe80:0000:0000:0000:0201:e8ff:fe8b:7720
00:59:27 : OSPFv3INFO: Ospf3_register_bfd ospf key 27648
00:59:27 : OSPFv3INFO: OSPFV3 Enabling BFD for NBRIP
fe80:0000:0000:0000:0201:e8ff:fe8b:7720 Interface Te 1/2
IfIndex 34145282
1338
(OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 512.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Description
Introduced on the Z9500.
Introduced on the S4820T, S4810, and Z9000.
Description
Debugging is on for all OSPFv3 packets and all interfaces.
Displays the time stamp.
Sending OSPF3 version..
Open Shortest Path First (OSPFv2 and OSPFv3)