Ipv6 Ospf Cost - Dell Z9500 Command Reference Manual

Version
9.2(1.0)
9.2.0.0
Usage
This command provides the flexibility to fine-tune the timer values based on
Information
individual interface needs when you configure ipv6 ospf BFD in CONFIGURATION
mode. Any timer values specified with this command overrides timers set using the
bfd all-neighbors command. Using the no form of this command does not
disable BFD if you configure BFD in CONFIGURATION mode.
To disable BFD on a specific interface while you configure BFD in
CONFIGURATION mode, use the keyword disable.

ipv6 ospf cost

Explicitly specify the cost of sending a packet on an interface.
Z9500
Syntax
ipv6 ospf interface-cost
Parameters
interface-cost
Defaults Default cost based on the bandwidth.
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
9.1.(0.0)
7.8.1.0
7.4.1.0
8.3.19.0
Usage
In general, the path cost is calculated as:
Information
10^8 / bandwidth
Open Shortest Path First (OSPFv2 and OSPFv3)
Description
Introduced on the Z9500.
Introduced on the Z9000, S4820T, and S4810.
Enter a unsigned integer value expressed as the link-state
metric. The range is from 1 to 65535.
Description
Introduced on the Z9500.
Introduced on the S4810 and Z9000.
Added support for C-Series.
Introduced on the E-Series.
Introduced on the S4820T.
1347