Spanning-Tree Mstp Edge-Port - Dell Z9500 Command Reference Manual

Defaults
•
•
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.5.1.0

spanning-tree mstp edge-port

Configures the interface as an MST edge port and optionally a Bridge Protocol Data Unit (BPDU) guard.
Z9500
Syntax
spanning-tree mstp edge-port [bpduguard [shutdown-on-
violation]]
Parameters
mstp edge-
port
bpduguard
shutdown-
onviolation
Multiple Spanning Tree Protocol (MSTP)
cost = depends on the interface type
priority = 128
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the keyword mstp then the keywords edge-port to
configure the interface as a Multiple Spanning Tree edge
port.
(OPTIONAL) Enter the keyword portfast to enable Portfast
to move the interface into forwarding mode immediately
after the root fails. Enter the keyword bpduguard to disable
the port when it receives a BPDU.
(OPTIONAL) Enter the keywords shutdown-on-violation
to hardware disable an interface when a BPDU is received
and the port is disabled.
1249