Command
INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.12.0
Usage
When you enter no fefd for an interface and fefd-global, FEFD is enabled on
Information
the interface because the no fefd command is not retained in the configuration
file. To keep the interface FEFD disabled when the global configuration changes,
use the fefd reset command.
Related
•
Commands
•
•
fefd disable
Disable FEFD on an interface only. This command overrides the fefd reset command for the interface.
Z9500
Syntax
fefd disable
To re-enable FEFD on an interface, use the no fefd disable command.
Defaults
Not configured.
Command
INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
1166
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
fefd disable
— disables far-end failure detection on an interface.
fefd reset
— enables FEFD globally on the system.
fefd mode
— changes FEFD mode on an interface.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Layer 2