Ip Pim Rp-Candidate - Dell Z9500 Command Reference Manual

Hide thumbs Also See for Z9500:

Table of Contents

pre- 6.1.1.1

First-hop routers use this address by to send register packets on behalf of source

multicast hosts. The RP addresses are stored in the order in which they are entered.

The RP is chosen based on a longer prefix match for a group. The RP selection

does not depend on dynamic or static RP assignments.

ip pim rp-candidate

To send out a Candidate-RP-Advertisement message to the bootstrap (BS) router or define group

prefixes that are defined with the RP address to PIM BSR, configure a PIM router.

ip pim [vrf vrf-name] rp-candidate {interface [priority]}

To return to the default value, use the no ip pim [vrf vrf-name] rp-

candidate {interface [priority]} command.

vrf vrf-name

Not configured.

CONFIGURATION

PIM-Sparse Mode (PIM-SM)

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Introduced on the E-Series.

(OPTIONAL) Enter the keyword vrf followed by the name of

NOTE: Applies to specific VRF if input is provided, else

applies to Default VRF.

Enter the following keywords and slot/port or number

information:

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 512.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN, enter the keyword vlan then a number from

(OPTIONAL) Enter the priority used in Bootstrap election

process. The range is zero (0) to 255. The default is 192.