Dell Z9500 Command Reference Manual page 1638

port number
timeout
seconds
key key
Defaults Not configured.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.4.1.0
8.3.7.0
7.7.1.0
7.6.1.0
7.5.1.0
6.2.1.1
Usage
To list multiple TACACS+ servers to be used by the aaa authentication login
Information
command, configure this command multiple times.
If you are not configuring the switch as a TACACS+ server, you do not need to
configure the port, timeout and key optional parameters. If you do not
configure a key, the key assigned in the tacacs-server key command is used.
Related
aaa authentication login
Commands
1638
(OPTIONAL) Enter the keyword port then a number as the
port to be used by the TACACS+ server. The range is from
zero (0) to 65535. The default is 49.
(OPTIONAL) Enter the keyword timeout then the number of
seconds the switch waits for a reply from the TACACS+
server. The range is from 0 to 1000. The default is 10
seconds.
(OPTIONAL) Enter the keyword key then a string up to 42
characters long as the authentication key. This
authentication key must match the key specified in the
tacacs-server key for the TACACS+ daemon.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for IPv6.
Introduced on the S4810.
Authentication key length increased to 42 characters.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— specifies the login authentication method.
Security